|
INSTALLATION OF
DROP DOWN BRACKETS
There are 2 sizes of drop down brackets, 6" for manual
systems and 10" for motorized systems.
The brackets come in pairs of 2, one pair to fit on each wall or ceiling
bracket.
Each end of the drop down brackets have 2 holes. One set of holes will attach to
the wall or ceiling bracket,
and the other set of holes will attach to a motor bracket or a drive assembly.
(depends on which rolleasy system you have, manual or motorized.)
The other pair of drop downs brackets, one end will again attach to the opposite
wall or ceiling bracket.
The other end of this set of drop down brackets will attach to an idle end. All
systems have an idle end
whether you have a manual or motorized system. The necessary hardware is
provided. After the drop down brackets are attached to your system, they will be
lower than the other motors, drive assemblies, and idle ends you
have attached to the wall or ceiling brackets. You can now add the roller to the
system.
See pictures:
SUPPORT---MOUNTING
CEILING
BRACKET UNIT ---
MOUNTING WALL BRACKET
UNIT---CUTTING EDGE
|
